Bare metal is the whole job
We do not apply anything. We take things back to bare substrate - the surface underneath decades of paint, rust and old coatings - and hand it off ready for whatever comes next. There is a real satisfaction in watching a part that looked beyond saving come out the other side clean.
Small parts come into the shop and go through a blast cabinet, media recovered and reused as we go. Larger structures - gates, railings, equipment - get blasted on site inside containment, with dust control and media recovery built into the setup rather than an afterthought.
We finish at bare metal. If your part needs color or protection after that, a powder coater is the natural next step - we strip it back, they finish it. We do not apply coatings ourselves.
